Operating the device

This section explains how to operate the device safely.

At departure

  1. Register the device with the Moeco online platform. You can also do this in advance.

  2. Switch the device to the active mode. To do this, press and hold the button for a few seconds.

    The light will blink green twice, stay green for a few seconds, and start indicating the battery percentage after a while. If the indication is different, e.g., red, see Troubleshooting for possible reasons.

    Once in the active mode, the device will connect to the Moeco platform.

  3. Attach the device to the cargo one of the following ways:

    • Place it inside the cargo crate.

    • Snap it to the cargo belt (Fig. 23).

    • Stick it clip side on the cargo crate using two-sided adhesive tape (Fig. 24).

    • Screw it to a flat wooden surface using two M4x50 or M3.5x50 self-tapping screws (not included).

Device clip

Fig. 23 Using the device clip

Using adhesive tape

Fig. 24 Using adhesive tape

On arrival

When the cargo arrives to destination, detach the tracker from the cargo, switch it to the storage mode using the Moeco platform, and put it into storage. Or you can leave it in the active mode and reuse it for another shipment.

To dispose of the device, follow the recommendations from section Disposal and recycling of this manual.